The Mitutoyo laser scan micrometer controller unit LSM-CU-A is compatible with the Laser Scan Micrometer models LSM-30-A and LSM-02-A. NOTE: To be usable, this controller requires the additional purchase of an interface unit. There are 4 interface units available depending on your system requirements; refer to the options. Choose when ordering from a metric only controller or a switchable metric/ inch controller.
- Measuring Functions
- Segment mode: 1 to 7 (1 to 3, transparent)
- Edge mode: 1 to 255
- Averaging method: Arithmetic average from 1 - 2048, Moving average from 32 to 2048
- Functions: Transparent object measurement, ultra-fine wire mode (LSM-02-A only), simultaneous measurement of two items, automatic workpiece detection, outlier elimination, judgment (lower limit/upper limit, multi-limit tolerance zone, target value and tolerance value), dirt detection for protective glass, sample measurement, analog output, parameter setting (measurement condition): 20, workpiece position, calibration, presetting, offset, statistical analysis, calculation of two or more sets, sensor model identification
- Standard Interface
- Indicator: Green LED light indicates power is on or shows red if an error occurs.
- Signal cable connector: Mini D-sub (15 pins)
- USB connector: Type-C
- I/O Connector: Separate terminal block with 18 pins
- Power supply connector: Separate terminal block with 6 pins
- Power supply DC +24 V ± 10%, 3.0 A or more.
- Weight 550 g (~1.2 lbs)
- Includes Socket for I/O terminal block, socket for power supply terminal block, grounding wire
Refer to the Laser scan micrometer brochure for more details on the system configuration.
NOTE: This item is not returnable.
